Filter
Top Products
24 Displaying and Adjusting the Image
3. Press the P
Power button again. The lamp turns off. When the
projector beeps twice, you can unplug the power cord.
(If the projector is mounted on the ceiling, you will need to wait
20 seconds for the projector to cool down before you can unplug
the power cord.)
If you want to turn the projector on again, make sure the orange
light is not flashing, then press the P
Power button.
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Close the A/V Mute slide.
Using the Direct Power On Function
The Direct Power On function enables faster setup. The projector will
start up automatically when you plug it in; you won’t have to press the
P
Power button.
Follow these steps to enable Direct Power On:
1. Press the
Menu button on the remote control and select the
Extended menu.
2. Choose
Operation and press Enter.
3. Choose
Direct Power On and press Enter.
4. Highlight
On and press Enter.
5. Press
Esc or Menu to exit.
The setting will take effect the next time you plug in the projector.
note
You can set the projector to
automatically turn off the
projector lamp and enter
“sleep mode” when it has
not received any signals for
30 minutes. This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the
P Power button.
If you are done using the
projector, unplug the power
cord. To enable sleep mode,
see page 56.
note
If a power outage occurs
when Direct Power On is
enabled and the projector is
plugged in, the projector will
start when the power is
restored.