Filter
Top Products
2-22 Using the Printer
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
2. Use the table below to select the appropriate paper thickness.
3. Close the cover.
Multipart forms
You can use carbonless multipart forms of up to five parts (one
original plus four copies). Before you print on the forms, set the
paper thickness lever as described in the previous section. These
tips will help you get good results:
❏ Use only multipart forms that are joined by spot gluing or
side-crimping, and that are free of wrinkles and waves. Never
load multipart forms joined by metal staples, tape, or
continuous gluing.
❏ If you need to adjust the loading position, use your software
program or change the loading position as described on
“Adjusting the top-of-form position” on page 2-15.
❏ When you use side-crimped multipart forms, the copies may
not align with the original. If this happens, raise the paper
guide.
Paper type Lever position
Standard paper (single sheets or continuous) 0
Multipart forms 2-sheet
3-sheet
4-sheet
5-sheet
0
1
2
3
Labels 1
Envelopes 2 to 4