Filter
Top Products
Replacing Ink Cartridges 27
10. Press the y
Stop button to begin charging the ink. This takes about 1 1/2
minutes. When it’s finished, the P
On light stops flashing and remains on,
and the
B ink light goes out.
Caution:
Never turn off the NX100 Series while ink is charging or you’ll waste ink. If the
B ink
light flashes, press the
y Stop button and press down all the cartridges securely.
Note:
If you replaced a cartridge while copying a document or photo, cancel printing and
make sure your original is still placed correctly on the document table. Then copy
your original again.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
nx_tx_100_qg.book Page 27 Wednesday, May 21, 2008 3:20 PM