Filter
Top Products
Paper Handling
The following section guides you through problems in handling
single sheets and continuous paper. If you are having problems
using the optional cut sheet feeder or the pull tractor, refer to
the section on Options starting on page 7-21.
Problem
Solution
Single sheets do
not feed properly.
The
LOAD/EJECT
buttons was pressed,
but the platen did not
move and paper was
not fed.
You may be tring to feed paper using
one of the control panel buttons while
the printer is on line (ON LINE light is on).
Press the ON LINE button once to set the
printer off line, then feed the paper.
After feeding the paper, press the ON
LINE button again to set the printer on
line. Refer to 3-4.
The paper may be set too far to the
right. If this is the case, the paper end
detector cannot sense the paper. Move
the left edge guide to its proper position,
and reinsert the paper between the edge
guides. Refer to 2-4.
Troubleshooting 7-13