Filter
Top Products
SelecType Settings
l
INTERFACE: If your computer has a serial interface, you
need to change the interface setting to Serial. If you are
using an optional interface board, be sure that the interface
setting is Parallel, regardless of the actual type of
interface you installed. See the section on interface boards
in Chapter 5 for more information.
l
BAUD RATE, PARITY: Set these only if you are using the
serial interface. These options do not display in SelecType
unless the interface is set to Serial. Check your computer
manual for the correct baud rate and parity settings. Your
computer and printer must have the same baud rate and
parity in order to communicate properly.
l AUTO LINE FEED: This setting should remain at its default
value (Off) in most cases. Most applications send automatic
line feeds at the end of every line. If all of the lines are
printing on top of each other, then set AUTO LINE FEED to
On.
l
DC1/DC3: This setting should also be left at its default value
(Disable) in most cases. See the explanation of these codes
in Chapter 9 for more information.
Using the Printer 3-13