Filter
Top Products
Epson SureColor T-Series User’s Guide
Basic Operations
39
Removing Cut Sheets
This section describes how to remove cut sheets when
printing is complete.
Buttons that are used in the following settings
1
Confirm that Paper Eject is displayed in the
control panel.
Keeping a hand on the cut sheets to prevent
them falling from the printer, press the Z
button.
2
The paper will be fully ejected from the printer
and can then be removed by hand.
Loading and Removing
Poster Board
This section describes how to load and remove poster
board from 0.8 to 1.5mm thick.
The printer can be used with board of the following
sizes.
A2/A1/B2/B1
*
/B1 landscape
*
/24 × 30 inch/30 × 40
inch
*
* Not supported by the T3270.
Loading Poster Board
Poster board requires space both behind and in front of
the printer. The approximate amount of space required
is shown below. If the printer is set up near a wall, make
sure there is enough space at the rear.
Note:
To remove paper that was loaded but not used, press the
( button and select Remove Paper.
Paper Size Front (a) Back (b)
A2 17.4 inches
(444 mm)
5.3 inches
(135 mm)
A1 27.2 inches
(691 mm)
15.0 inches
(382 mm)
24 × 30 inch 24.1 inches
(612 mm)
11.9 inches
(303 mm)
30 × 40 inch 34.1 inches
(866 mm)
21.9 inches
(557 mm)
c
Important:
Insert the paper just before printing. The roller
may leave an impression on paper that is left in
the printer.