Filter
Top Products
161
Maintaining and Transporting the Printer | 161
Changing the Date and Time
1. Press r Menu.
2. Press d until
MAINTENANCE is highlighted, then press r.
3. Press d until you see
CLOCK SETTING, then press r.
4. Use the d, u, and r buttons to set each item in the date and time,
displayed in the following format:
MM/DD/YY HH:MM.
5. Press
OK to save the setting.
Using Maintenance Mode
Maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use
maintenance mode to do the following:
• Change the language or units of measurements used on the printer’s
control panel menus.
• Adjust the maximum value for roll paper tension.
• Run a “super strong” cleaning cycle.
• Return all of the printer’s control panel settings to their default values.
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the
button, then press the P power button and
hold it until the printer turns on and the LCD displays
MAINTENANCE MODE.
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
• To change the language on the LCD display, press d to highlight
LANGUAGE, then press r. Press d until you see the language you
want, then press
OK to select it. The printer exits maintenance
mode and returns to normal operation.
Note: You can use the
PRINTER SETUP menu to
enable the roll paper
counter, paper size
check, and several other
printer features. For more
information, see
page 217.