Filter
Top Products
180
180 | Solving Problems
NOZZLE CLOG DETECTED
NOT ENOUGH EMPTY
SPACE IN MAINT TANK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough space in
the maintenance tank to
perform cleaning.
Select YES, then follow the instructions to
replace the maintenance tank.
PAPER CUT ERROR
REMOVE UNCUT PAPER
Roll paper was not cut
correctly.
Press the button and open the front
cover. Remove the uncut paper.
The cutter may be blunt or
incorrectly installed.
Reinstall or replace the cutter if necessary;
see page 162.
PAPER EJECT ERROR
REMOVE PAPER FROM
PRINTER
Roll paper is used with the cut
sheet setting.
Press the button and remove the paper.
PAPER ERROR
LOAD PAPER CORRECTLY
Paper is not loaded correctly. Press the button, then reload paper
correctly.
PAPER JAM
REMOVE PAPER
Paper has jammed in the
printer.
Press the button and remove the
jammed paper; see page 191 for more
information.
PAPER LOW The paper roll is almost
finished.
Replace the roll.
PAPER OUT
LOAD PAPER
No paper is loaded. Load paper.
The button has been
pressed with no paper loaded.
Press the button, then load paper.
Paper ran out during printing. Press the button and remove the roll
paper core. Then load another roll.
PAPER RELEASED
LOAD PAPER
The button has been
pressed.
Load paper, then press the button.
PAPER SENSOR ERROR
PRESS THE BUTTON
LOAD DIFFERENT PAPER
The paper is not detected. Press to clear the error, then select
the right paper.
PAPER SETTING ERROR
CHECK THE PAPER SOURCE
IN THE DRIVER SETTINGS
AND LOAD PAPER
CORRECTLY
The paper source selected in
the printer driver and the
control panel do not match.
Check the Paper Source or Paper Size
settings and make sure the paper is loaded
correctly.
Message Explanation Response