Filter
Top Products
PipeRider® Cable Modem User's Guide HM200c/HM201c
Installation: USB for Windows 98/2000/Me
Follow the steps below in the order given:
Connect the coaxial cable between the
service provider's cable jack and the
cable connector on the back of the
modem. Be sure not to bend the center
wire on the connector. Hand tighten both
connectors.
1.
Plug the DIN connector of the power
supply cable into the Power connector on
the back of the cable modem. Plug the
power supply into a surge protected
power source.
2.
The USB drivers are located on this
PipeRider Support CD. The CD must be in
the CD-ROM drive when the USB cable is
connected.
Insert the square plug of the USB cable
into the USB port on the back of the cable
modem. Insert the rectangular plug of the
USB cable into the USB port on the back
of the computer.
3.
Once the cables are connected, the
computer will automatically search for the
USB driver specific to your operating
system. If prompted for the location of
the driver, enter the drive letter of your
CD-ROM drive. Follow the on screen
prompts to install the driver.
4.
Reboot your computer when prompted.5.
Note: From time to time, updates to USB drivers become available. After you've completed the installation of
your cable modem, it is recommended that you visit the Ericsson PipeRider Internet site periodically to download
the latest version of the drivers.
Note: In the event of an electrostatic discharge (ESD) to the exposed metal surfaces of the cable modem, the
USB port may become inoperable. If this occurs, disconnect and then reconnect the USB cable from the back of
the cable modem. If this does not restore USB operation to the cable modem, power the modem off and on by
unplugging the modem, waiting a minute, and then plugging it back in.