Filter
Top Products
Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©
Page 69 www.PressureSystems.com
Command 'c' — Sub-command Index 05: Select Data in a Stream
This sub-command sets options that cause a specified stream to deliver specific kinds of
information to host. By default, only Pressure EU Data are delivered.
Command
“c 05 st bbbb”
‘c’ is the command letter.
‘ 05’ is the sub-command index (ii) for Select Data.
‘ st’ is the stream id digit (1, 2, or 3, =0 no allowed).
‘ bbbb’ is the hex option field (bit map) to select which options will be
returned in the data stream. (See table)
NOTE: all parameters are separated by a space.
Response
"A"
‘A’ is the acknowledge letter.
Description: If this sub-command is never executed for a particular stream, then just
Pressure EU Data are delivered (by default) in that stream following the fixed
format binary header. However, this sub-command may also delete these
default pressure readings from a stream (by not specifying them) — as well as
add other selected acquired data to a stream (by specifying them).
The bit map values (shown in the following table) may be added together to
specify all the actual data groups that will be delivered in each packet of the
specified stream. The first two table entries, if their “bits” are specified, will
cause two-byte binary (16-bit, big endian) status values to be delivered in the
stream packet (immediately following the stream header). The third table entry, if
specified, will cause the Pressure EU Data to be delivered (next), per the
specified format (f), and for just the channels specified (P&S, then 16-1), in the
configured stream. The remaining table entries (*) will cause other special data
groups (i.e., raw pressures and EU temperature values, also in A/D counts or
voltage forms) to also be delivered in each stream packet. Each of these special
data groups is also output, if its “bit” is specified, in the order of its table entry
(within the packet). Each group will also have a datum per the specified
channels, and be in the specified format (per f).
Note
Selecting too many other data groups will compromise
module performance.