Filter
Top Products
Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 4 • Programmer’s Guide
Virtual Output MUTES VM
1
•
2
• • • • •
64
Mut
Notes:
1. Start output is always
Ø
1 for Room PRESET, because room has max. of 16 outputs assigned.
2. All “VI” values in responses are 2 numeric characters (i.e. 12 or
Ø
3) or “na” indicating nonexistent
virtual outputs.
3. In “VA” View, any outputs that do not follow show as “- -“ in response.
4. Rvo = Virtual Output assigned to specified “room” (up to 16 total).
RGB DELAY COMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Read RGB Delay (for 1 ch.)
D Out •Dly
Set RGB Delay (for 1 ch.) d * Out •Dly
Note: Where = delay in 1/2 second increments (i.e.
Ø
=
Ø
sec, 1
Ø
= 5.
Ø
sec)
DIRECT W RITE OF
GLOBAL P RESETS C OMMAND ASCII (HOST-SWITCHER)RESPONSE (SWITCHER-HOST)
Start Write Mode
P Write Preset Ready
End Write Mode p End Write Preset
Example P32 Write Preset 32 Ready
1*1!
1*2&
1*3%
:
:
1*64$
p End Write Preset 32
Notes:
1. Any non-output switching or invalid command between the Start and End commands will be
ignored.
2. If there is no activity for 5 seconds while in write mode, then error E17 occurs.
3. No front panel switching (Actual Switching) is allowed during the Start and End commands.
4. If an End (
p) command is issued with no Start command, then error E1
Ø
occurs.
QUICK RECALL OF
GLOBAL P RESET C OMMANDS ASCII (HOST-SWITCHER)RESPONSE (SWITCHER-HOST)
Quick Recall Preset
. RPR
Notes:
1. If the Quick Recall Preset (
.) command is issued without an active write, then error E1
Ø
occurs.
2. Complete backplane switch within 6
Ø
mS (apprx.) after receipt of the command.
3. Recall must take place 1
ØØ
mS after End Write Mode command ( p).
4. Quick recall command only recalls last entered direct write preset.
SET N AMES C OMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Read Global preset name
NG
Write Global preset name nG , NamP
Read Room preset name NP *
Write Room preset name nP * , NamP
Read Room Name NR
Write Room Name nR , NamR
Read Virtual Input Name NI
Write Virtual Input Name nI , NamI
Read Virtual Output Name NO
Write Virtual Output Name nO , NamO
ZAP C ONFIGURATION C OMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)
Zap All Global presets & names
zG ZapG
4-7
ADVANCED I NSTRUCTION SET AND SIMPLE I NSTRUCTION S ET COMMANDS (PAGE 2 OF 3)
VIEW C OMMANDS ASCII (HOST-SWITCHER) RESPONSE (SWITCHER-HOST)