Filter
Top Products
vDTP T EU 332, DTP T EU 232, DTP T MK 332, and DTP T MK 232 • Contents
Introduction ................................................... 1
About this Guide ................................................. 1
About the Switching Transmitters ....................... 1
Features ............................................................. 3
Installation and Operation ........................... 4
Installation Overview ........................................... 4
Installing the Junction Box or European Cable
Channel System ................................................ 6
Rear Panel and Side Panel Features ................... 7
Mounting the Switching Transmitters .................. 9
Front Panel Connectors .................................... 10
Connection and Wiring Details .......................... 12
HDMI Connector........................................... 12
VGA Connector Wiring ................................. 13
TP Cable Termination and
Recommendations ...................................... 13
IR and RS-232 Connector Wiring ................. 14
Power Supply Wiring .................................... 15
Operation ......................................................... 17
Indications .................................................... 17
Switch Modes............................................... 17
EDID ............................................................. 17
Reset ............................................................ 17
Troubleshooting — If no Image Appears ........... 18
Remote Control ........................................... 19
Simple Instruction Set Control .......................... 19
Host-to-Switcher Communications ............... 19
Switcher-Initiated Messages ......................... 19
Error responses ............................................ 20
Timeout ........................................................ 20
Using the Command and Response Table .... 20
Product Configuration Software ........................ 26
Installing the Software ................................... 26
Starting the Program .................................... 28
Updating the Firmware ................................. 30
Contents