Filter
Top Products
i
MLC 104 Series MediaLink • Table of Contents
Table of Contents
Chapter One • Introduction ...................................................1-1
About this Manual ....................................................................1-2
About the MLC 104 Medialink Controllers ........................ 1-2
About Global Configurator ....................................................1-3
System Requirements ...............................................................1-4
Installing the Software ............................................................1-4
Updating Firmware ...................................................................1-5
Chapter Two • MLC 104 Series Hardware Setup ......2-1
Right Side Panel Features and Connections .....................2-2
Left Side Panel Features and Connections ........................2-6
Front Panel Features and Basic Operation ........................2-7
Buttons ...................................................................................2-7
Volume control .......................................................................2-8
Configuration (host control) port .........................................2-8
Chapter Three • MLC 104 Series Software Setup ....3-1
Step 1: Download Device Drivers .......................................3-3
Step 2: Create a New Project ...............................................3-4
Step 3: Add an MLC 104 IP or MLC 104 Controller and
Define its Location ....................................................................3-5
Step 4: Define E-mail Settings (IP model only) ...............3-7
Defining e-mail server settings .............................................3-8
Setting up e-mail notifications .............................................3-8
Adding e-mail contacts ........................................................3-10
Step 5: Add a Serial or IR Device .......................................3-11
Downloading additional drivers .........................................3-11
MLC 104 series port configuration .....................................3-11
Adding a serial driver ..........................................................3-11
Adding an IR driver ..............................................................3-12
Step 6: Configure the Front Panel Buttons ....................3-14
Configuring an input button ...............................................3-14
Configuring the On and Off buttons ..................................3-15
Step 7: Create a Display Shutdown Schedule ...............3-16
Step 8: Create a Display Lamp Hour Warning E-mail
(IP model only)..........................................................................3-18