Filter
Top Products
3
Getting
Started
12
A. Choosing a
Good Location
Place the unit in a location with adequate air
circulation to prevent internal heat build up.
1. Use the dimensions specified in Section 11 as a
guideline for the minimum clearances to the unit.
NOTE
Allow for adequate clearance above the unit to
accommodate the height of the unit with its covers open.
2. Do not install unit (a) near heat sources such as
radiators or air ducts, or (b) in a place subject to
direct sun-light, excessive dust, mechanical
vibration or shock.
B. About
Moisture
Condensation
If the unit is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense inside the unit. Should this
occur, print quality may not be optimum. Leave
the unit turned OFF in a warm, dry room for
several hours before using. This will allow the
moisture to evaporate.
C. Unpacking and
Inspection
While unpacking your printer, inspect the carton to
ensure that no damage has occurred during
shipping. Make sure that all supplied accessories
are included with your unit. The following items
should be included with your Color ID Card
Printer:
■
Printer
■
Power Cord
■
Cleaning Roller
■
Printer Driver Diskette (3.5Ó)
■
32-bit Print Spooler Software; for use in
Windows 95 only
■
Warranty Statement and Registration Card
■
This manual and other printed information
Save the carton and packing materials. They will
come in handy when transporting the unit or
shipping it for service.