Filter
Top Products
Adjustment to the second Internal Card Guide is now
complete.
C. Adjusting the
Card Separator
Flap
49
Metal Roller
Card Input Guides
Card Input Tray
Card Input
Hopper Door
Card
Feed
Roller
The Card Separator Flap resides inside the printer
and helps prevent two cards from feeding
simultaneously. This flap is adjustable to
accommodate varying card thicknesses. Although
the Card Separator Flap will automatically adjust
to slight card thickness variations, a manual
adjustment should be made in order for the printer
to consistently feed single cards which vary from
the standard CR-80 .030Ó card thickness. To adjust
the Card Separator Flap, refer to the following
steps:
1. Open the Card Hopper Door located on the
right-hand side of the printerÕs exterior by
grasping the top of the door and pulling straight
down. Allow the door to swing completely open.
2. Remove all cards from the Card Hopper.
3. Open the top-right cover of the printer by
pressing its Cover Release Button. Allow the cover
to swing up and open.
4. Remove the ribbon from the printer.
5. As you are looking straight into the Card
Hopper, locate the two single screws which reside
in the upper corners of the back plate of the Card
Hopper. You will find one screw to the right of the
right Card Input Guide and one screw to the left of
the left Card Input Guide. Loosen these screws.