Filter
Top Products
50
6. As you are looking inside the printer from the
front, locate the two single screws located just to
the left of each end of the first Card Feed Roller.
Rotate these screws to adjust the Card Separator
Flap.
7. Rotate the screws clockwise to move the Card
Separator Flap upward or counter clockwise to
move the flap downward. If inserting thicker cards,
move the Card Separator Flap downward. If
inserting thinner cards, move the flap upwards.
When adjusted properly, the space between the
Card Separator Flap and the first Card Feed Roller
should be approximately the same as the thickness
of your card stock. To accurately view this space,
look directly into the Card Hopper and locate the
shaft of the Card HopperÕs first Metal Roller and
the shaft of the first Card Feed Roller (see
illustrations to locate these items). With the spring-
loaded Card Input Tray pressed down, direct your
line of sight into the Card Hopper so that the shaft
of the Metal Roller appears directly in front of the
shaft of the Card Feed Roller. Only when this line
of sight is established can you accurately judge and
adjust the position of the Card Separator Flap.
Remember that the flap must always be adjusted
parallel to the Card Feed Roller.
8. Once you have adjusted the Card Separator
Flap to the optimum level, tighten the screws
loosened in step 5 to secure the Card Separator Flap
in place.
9. Adjustment to the Card Separator Flap is now
complete. Replace the ribbon and cards, and shut
the printerÕs top-right cover and Card Hopper
Door to begin printing.
Card Flap
Adjustment
Screws
Card
Feed Roller
Cleaning Roller Assembly