Filter
Top Products
FS-8700-101_Setra Model 370 Digital Pressure Gage Manual Page 9 of 23
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldServer.com
4.4. Client Side Map Descriptors
4.4.1. FieldServer Related Map Descriptor Parameters
Column Title Function Legal Values
Map_Descriptor_Name Name of this Map Descriptor
Up to 32 alphanumeric
characters
Data_Array_Name
Name of Data Array where
data is to be stored in the
FieldServer
One of the Data Array names
from “Data Array” section
above
Data_Array_Offset
Starting location in Data
Array
0 to maximum specified in
“Data Array” section above
Function
Function of Client Map
Descriptor
RDBC
4.4.2. Driver Related Map Descriptor Parameters
Column Title Function Legal Values
Node_Name
Name of Node to fetch data
from
One of the node names specified in
“Client Node Descriptor” above
Data_Type
This commonly used
parameter has no special
meaning to this driver and
may be omitted.
Register, Coil, AI, DI
Length Length of Map Descriptor
The driver knows the correct length
for the various Map Descriptors and
will prompt you accordingly if an
invalid length is specified.
Pressure : Set Length 5
Status: Set Length 14
Verification Info: Set length 100.
Address
This commonly used parameter has no special meaning to this
driver and may be omitted.
Gage_Function*
Specifies what data should
be read and stored.
If you omit this parameter
then the driver assumes
you are reading pressure.
Pressure, Status, Verify
4.4.3. Timing Parameters
Column Title Function Legal Values
Scan_Interval Rate at which data is polled ≥0.001s