Filter
Top Products
FS-8700-105_National_Time_and_Signal_FACP Manual Page 19 of 25
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Message Interpretation and Corrective Action
NATS:#02b Err. Bad Port-
Type=%c. Expected I/O/F/P.
NATS:#05 Err. Bad Sub-
Port=%d.
The sub-port type has not been specified for the Map
Descriptor.
∗
NATS:#06a Err. Bad Sub-
Port-Type=0x%x. Expected
I/O/F/S/N.
NATS:#06b Err. Bad Sub-
Port-Type=%c. Expetced
I/O/F/S/N.
A Map Descriptor is being validated and has been rejected
because the ‘Sub-Port-Type’ has not been correctly
specified.
NATS:#07 Err. Loop Not
specified
The Loop has not been specified for the Map Descriptor.
∗
NATS:#08 Err. Board Not
specified
The Board has not been specified for the Map Descriptor.
∗
NATS:#09 Err. Parse: Found a
'%c' instead of a 'L' for Loop.
A message is being processed to determine the event that
is being reported. During the processing an error was
found. If this error occurs occasionally then you could
assume that it is an occasional corrupt message. You
could determine this yourself. The driver prints a copy of
the incoming messages on the ‘F’ screen (when using
Ruinet). Note the messages and look for corruption. If
there is any take steps to improve the connection.
If it occurs frequently then assume that there is a
systematic error. Take a log, note the error and call Tech
Support.
Valid Port Types are I/O/F/P.
NATS:#10 Err. Undefined
Loop
The parameter heading ‘Loop’ has been provided on the
Map Descriptor in the configuration CSV file, but the
parameter value has not been specified.
∗
NATS:#11a FYI Validation
ignored for simulation.
MD=%s
This message is normally only printed when the driver is
being tested for QA purposes. If it is printed during
normal operation, take a log and call Technical support.
There are a number of variants of this message. Be sure to
quote the correct one when reporting the error.
NATS:#12 Err. Undefined
Board
The parameter heading ‘Board’ has been provided on the
Map Descriptor in the configuration CSV file, but the
parameter value has not been specified.
∗
NATS:#13 Err. Undefined
Sub-Port
The parameter heading ‘Sub-Port’ has been provided on
the Map Descriptor in the configuration CSV file, but the
parameter value has not been specified.
∗
NATS:#14 Err. Undefined The parameter heading ‘Port-Type has been provided on