Filter
Top Products
FS-8700-112 FCI 7100 Series Driver Manual Page 11 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Column Title Function Legal Values
Address
This parameter is only considered for those
Map Descriptors whose ‘Event Type’ is
Module or Sensor. It specifies the starting
module or sensor number. The length
parameter the determines the range of the
sensor/module numbers
1..99
Store As
By default the driver stores using the ‘Index
Value’ Method.
Set this parameter to ‘Bit’ to have the driver
use the primary Data Array to store using the
‘Bit Storage’ Method.
These methods are described in Appendix
A.3
Bit, Index_Value
DA_Bit_Name
If the default ‘Store As’ is specified or if the
parameter is omitted then you can specify a
secondary array using this parameter - the
driver will store event data as ‘Bit Storage’ in
the secondary array (and as ‘Index Values’ in
the primary array.) These methods are
described in Appendix A.3
One of the Data
Array names from
“Data Array”
section above
Clear on Reset*
If a reset if received you can prevent the
driver resetting the Data Array Points
associated with the Map Descriptor by
specifying this parameter.
Yes, No