Filter
Top Products
FS-8700-112 FCI 7100 Series Driver Manual Page 16 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Appendix A.2. Extending the Event Table
New event causes may be added to the Event Table and the index value or category of
existing event causes modified by adding a section to the configuration CSV file. The
examples below illustrate this:
Example 1: Index value of 'Trouble' is updated to a new value of 100
Driver_Table
Event_Type_Description, Event_Type_Index_Value, Event_Type_Category , Protocol
TROUBLE, 100, 4, FCI_7200
Example 2: New Entry is added
Since it has been added as category=3, only MD's with 'Event Type' set to Alarm or ANY
will capture messages with this event description
Driver_Table
Event_Type_Description, Event_Type_Index_Value, Event_Type_Category, Protocol
DESTROYED, 51, 3, FCI_7200
For categories use the following values
'Other' = 1
'Fault' = 2
'Alarm' = 3
'Trouble' = 4
Appendix A.3. How Data is stored
All messages less than 102 characters long are discarded. All other messages are
processed as follows:
• The driver determines if the message is a Zone, Relay, Loop, Sensor, Module or Panel
message.
• The driver finds all Map Descriptors with matching ‘Point Type’ parameters.
• The event category is determined.
• Map Descriptor selection is refined based on whether the ‘Event Type’ matches or has
been defined as “Any:
• The driver determines the Loop. Relay, Zone, Sensor and Module numbers from the
message and refines its selection of Map Descriptors by selecting those that match the
values determined from the message.
• The selected Map Descriptors are now used to determine a data array and offset at
which to store the data.
• Finally the driver checks the ‘Store As’ parameter. If it hasn’t been specified then ‘Index
Value’ storage is assumed. If it has been specified as ‘Bits’ then the driver will perform
‘Bit Storage’. In cases where the Map Descriptor has both a primary and secondary
Data Array, the driver will use ‘Index Value’ storage using the primary data array and ‘Bit
Storage’ using the secondary array.