Filter
Top Products
Page 23 of 29FS-8700-66_GE-SNP Manual Page 23 of 29
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com
No
Message Description
17
GE_STAT_MBOX_PLC_STAT
18
GE_STAT_MBOX_PRIV_LVL
19
GE_STAT_NO_NODES
If a poll for a SNP Node is received and
there are no Nodes defined or there is no
matching Node.
20
GE_STAT_CONNECT_ATTEMPT
Counts the number of time a connection
attempt is made
21
GE_STAT_CONNECT_RESPONSE
Counts the number
of times the driver
responds to connection attempts when
acting as a Server
22
GE_STAT_CONNECT_NO_RESPONSE
Counts the number of connection attempts
that timed out.
23
DRV_DLL_CLIENT_SENDS_MSG
Counts the number of connection and poll
messages se
nt by the Client (whole
messages only)
24
DRV_DLL_CLIENT_SENDS_ACKNAK
Counts the number of simple ack/nak’s sent
by Client. These ack/nak’s indicate
messages if formatted correctly, however
the device can not necessarily respond to
the request.
25
DRV_DLL_CLIENT_SENDS_BYTES
Byte count includes ack/nak's sent and all
fragments and connection
26
DRV_DLL_SERVER_SENDS_MSG
27
DRV_DLL_SERVER_SENDS_ACKNAK
28
DRV_DLL_SERVER_SENDS_BYTES
Same as for Client
29
DRV_DLL_CLIENT_RCVS_MSG
Counts ack/nak’s, and all message
fragments excluding attach responses
30
DRV_DLL_CLIENT_RCVS_BYTES Byte count from above messages
31
DRV_DLL_SERVER_RCVS_MSG
Counts message fragments and ack/nak’s
rcvd from Client bu
t excludes Client
responses to Server fragments
32
DRV_DLL_SERVER_RCVS_BYTES Byte count for above messages
33
DRV_DLL_TIMEOUT
Count of timeouts caused by no response
or ic_timeout at the DLL layer
34
DRV_DLL_ERROR
Count of the number of times that the DLL
layer went into an error state.
35
DRV_DLL_ERROR_CODE
The error code from the most recent DLL
error is stored here.
36
GE_STAT_DRV_ACT_NODE_OFFLINE_R
Corresponds to slave driver actions i
n
responding to a poll. The polled Node is
offline.
37
GE_STAT_DRV_ACT_NO_MAPDESC_R
Corresponds to slave driver actions in
responding to a poll. There is no Map
Descriptor that can be used to process the
poll from the Client.