Filter
Top Products
Page 28 of 29FS-8700-66_GE-SNP Manual Page 28 of 29
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com
Decimal
Hex Description
-62 0C2 The OEM key is NULL (inactive).
-63 0C1 Invalid block state transition.
-64 0C0 Bad OMF record checksum in store.
-65 0BF Illegal OMF record type/data contents.
-66 0B Bad Block Type given in Load/Store.
-67 0BD
Block Set (subblock name) not found.
-68 0BC
Block Type (e.g., data) not found.
-69 0B Maximum length of a partial store exceeded.
-70 0B Block Set already exists, cannot create.
-71 0B9 Executable flag in TYPDEF record not set.
-72 0B8 Size of the Segment Selector Table in TYPDEF record is not correct.
-73 0B7 Segment length in Verify not equal to the segment length of block in the PLC.
-74 0B6 Cyclic Redundancy Check (CRC) checksum comparison in Verify failed.
-75 0B5 Additive checksum comparison in Verify failed.
-76 0B4 Attempt to alter interrupt list in MAIN DECL BLOCK during RUN MODE.
-77 0B3 Length limit exceeded; includes read past end of transferred data, writes past
ofprogram block.
-78 0B2 Program block already exists and cannot be replaced.
Minor Error Status Codes: Program Load and Store Requests
Decimal,
Hex,
Description
80 50
Problem with sending mail to the slave Service Request task. (Series 90-70 PLC
CPUs only).
81 51
Problem with getting mail from the slave Service Request task. (Series 90-70
PLC CPUs only).
85 55
Slave SNP task timed out before receiving SRP response. (Series 90-70 PLC
CPUs only).
86 56
Slave SNP task could not find the requested Datagram connection. (Series 90-70
PLC CPUs only).
87 57
Slave SNP task encountered an error in trying to write the Datagram. (Series 90-
70 PLC CPUs only).
88 58
Slave SNP task encountered an error in trying to update the Datagram. Series
90-70 PLC CPUs only).