Filter
Top Products
46
• Suspend Mode
When enabled and after the set time of system inactivity, all devices except the
CPU will be shut off. The settings are: 1/2/4/8/12/20/30/40 Min, 1 Hour,
and Disabled.
• HDD Power Down
When enabled and after the set time of system inactivity, the hard disk drive
will be powered down while all other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15Min and Disabled.
• Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter
the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.
• Wake-Up by PCI Card
This will enable the system to wake up through PCI Card peripheral.
The settings are : Enabled and Disabled.
• Power on by Ring
• Wake-Up on LAN
To use this function, you need a LAN add-on card which support power on
functions. It should also support the wake-up on LAN jumper (JWOL1).
• CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 25.0%, 37.5%, 50.0%,
62.5%, 75.0%, 87.5%.
• Resume by Alarm
This function is for setting date and time for your computer to boot up. During
Disabled, you cannot use this function. During Enabled, choose the Date and
Time Alarm:
Date(of month) Alarm You can choose which month the system will
boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm You can choose what hour, minute and second
the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes
to the operating system, before this function will work.
Enabled Wake up on LAN supported.
Disabled Wake up on LAN not supported.
She_Chp2_28-52 19/1/00, 16:2846