Filter
Top Products
17
Table 4.1 Parameters List
Parameter Value Description
fjgi When using PRIMEPOWER250/450
secondary LAN port, please set
name="fjgi".
FJSV,pgtb When using PCI card PW008GE5,
please set name="FJSV,pgtb".
name
FJSV,pgsb When using PCI card PW008GE4,
please set name="FJSV,pgsb".
parent Please refer to “4.3.2.1.2 How to Set
Parameter”.
The location of the device node in a
device tree is specified.
unit-address Please refer to “4.3.2.1.2 How to Set
Parameter”.
The address within a device node is
specified.
On (Default) AutoNegotiation is enabled. (In this
setting, unable to connect to the
remote device of a fixed mode.)
When you use 1000Mbps, please use
in Autonegotiation_A="On" (default)
mode.
AutoNegotiation_A
Off AutoNegotiation is disabled. (Fixed
mode)
Auto (Default) Connect in 1000/100/10Mbps by the
connection partner.(This can be set
when AutoNegotiation_A="On".)
1000 Connect in 1000Mbps.
100 Connect in 100Mbps.
LinkSpeed_A
10 Connect in 10Mbps.
Both (Default) Indicating that both Full-Duplex and
Half-Duplex are being supported.
(This can be set when
AutoNegotiation_A="On".)
Half Half-Duplex operation is allowed.
DuplexCapabilities_A
Full Full-Duplex operation is allowed.
Auto (Default) A flow control is performed according
to a setup of partner equipment.
Rem Only the flow control from the remote
machine is allowed. The flow control
to the remote machine is not allowed.
LocSend Only the flow control from the main
unit is allowed. The flow control from
the remote machine is not allowed.
FlowControl_A
None Flow control is disabled.