Filter
Top Products
74
Is the shipping lock set at operating
position?
YES
Set the shipping lock to
correctly position.
NO
Load document correctly on
ADF paper chute.
Are the document loaded correctly
on the ADF paper chute?
NO
YES
Is the ADF closed completely?
YES
Is the interface cable connected
correctly?
NO
Remove all documents from
the ADF paper chute. Then
open and close the ADF.
NO
Connect interface cable
correctly.
YES
Symptom 3
The scanning does not start.
(when using scanner on SCSI
interface)
Is the SCSI ID set correctly?
YES
NO
Set SCSI ID correctly by
SCSI ID switch on rear of
scanner.
Does the Function No. display
indicates any alarm?
NO
The scanner operation is
normal.
YES
Does the alarm state remain
displayed even after the scanner
has been turned off and on
again?
YES
NO
The scanner operation is
normal.
Contact the manufacturer's
authorized service center.