Filter
Top Products
12-02-2003
Page 3-25 of - 3-25 -
51
3.8.21 Initialise Printer
[Name] Initialise
[Format] ASCII SYN
Hex 16
Decimal 22
[Description] When the printer controller receives this byte a reset of
the printer will be initialised. This command can be
treated even if buffer is full.
3.8.22 Request Software version
[Name] Request software version
[Format] ASCII ETB
Hex 17
Decimal 23
[Description] When the printer controller receives this byte the
software version will be transmitted. This command can
be treated even if buffer is full.
3.8.23 Request Status
[Name] Request status
[Format] ASCII CAN
Hex 18
Decimal 24
[Description] When the printer controller receives this byte a status
byte will be transmitted. This command can be treated
even if buffer is full.
The bit definitions is as follows
Bit Status 0 1
0 Near end Logic level is low Logic level is high
1 Paper Present Absent
2 Temperature Not too hot Head too hot to print
3 Head Closed Open
4 Paper Jam No error Error
5 Rxerror No error Rx error
6 Buffer Not full. Full (less than 16 bytes left)
7 Always 1.
3.8.24 Request Analog voltage.
[Name] Analog voltage
[Format] ASCII EM
Hex 19