Filter
Top Products
12-02-2003
Page 2-9 of - 2-9 -
51
2.5 Settings
Following below description can change default settings. Baud rate is
default 115.200, however standard PC´s today cannot handle this Baud
rate. Windows OS does not support speed higher than 115.200 Baud,
even when setup menus can be set to higher speed. In order to obtain
higher speed you need to install 3
rd
part utility program on PC. Please
visit www.if-com.com for further information.
1. Turn off power
2. Press Key 1 low while power up. Board is now in setting mode.
Text will be printed on paper for further information
3. By activating key 1 and 2 you can change following parameters:
a. Test printout
b. Select Command set (optional)
i. I/F-COM command set
ii. Seiko compatible command set (Optional)
iii. Fujitsu compatible command set (Optional)
iv. APS compatible command set (Optional)
v. ESC/POS compatible command set (Optional)
c. Baud rate
i. 9600
ii. 19.200
iii. 38.400
iv. 57.600
v. 115.200
vi. 230.400
vii. 460.800
d. Parity
i. 0
ii. 1
e. Data bit
i. 7
ii. 8
f. Stop bit
i. 1
ii. 2
g. Flow control
i. None
ii. Hardware
iii. Xon/Xoff
h. Dot size of printer
i. 384 dots
ii. 432 dots