Filter
Top Products
Chapter 6 Setting Up the VMware ESX Server
6.1 Setting Up for VMware vSphere
ETERNUS DX Disk storage systems User’s Guide -Server Connection- (iSCSI) for VMware® ESX
23
Copyright 2012 FUJITSU LIMITED P3AM-3412-11ENZ0
6.1.4 Setting the Software Initiator
Enable Software Initiator in VMware ESX.
Procedure
1 Select the [Configuration] tab on vSphere Client and click [Storage Adapters].
2 Select the target iSCSI Software Adapter and click [Properties...].
3 Click [Configure] on the [General] tab.
4 Select the [Status-Enabled] checkbox and click the [OK] button.
5 Confirm that the [Enabled] checkbox is selected under "Status" on the [General]
tab and click [Configure] again.
6 Confirm that the iSCSI name is displayed in the "iSCSI Name" column and click
the [Cancel] button.
7 Select the [Dynamic Discovery] tab and click the [Add] button.
8 Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk
storage system as the iSCSI server IP address, confirm that the port is set to
"Port 3260" (default), and click the [OK] button.