Filter
Top Products
88
Stylistic LT800P Tablet
Troubleshooting 11
This section contains troubleshooting information, including causes and actions, for
problems you may find while using this device.
Troubleshooting Table 11
Problem Possible Cause Possible Solution
An exclamation
mark (!) or cross (x)
is attached to
[Intersil PRISM
Wireless LAN PCI
Card].
A failure to
recognize the
device.
Restart the computer.
A failure in
installing the driver.
Restart the computer.
Other computers
are not displayed
when the [Network
Computer] icon is
double-clicked.
The network has
not been set up
correctly.
Check the setting for the protocol, work-
group, and sharing.
To check this, you need a different proce-
dure, depending upon the operating
system that you use. Refer to the appro-
priate section of this chapter.
It takes time before
the network is
searched and the
computer
connected is
displayed.
Perform the following steps to search for
the computer.
■
Click [Start] -> [Search] -> [Other
Computers].
■
Enter the computer name that you are
connecting to in [Name], and click
[Search].
■
Double-click the icon of the computer
that has been searched.
A failure in
installing the driver.
Make sure that the driver is correctly
installed.
The TCP/IP
protocol is not
installed, or, the IP
address is not set
correctly.
Make sure that the TCP/IP protocol is
installed. To check this, you need a
different procedure, depending on the
operating system that you use. Refer to
the appropriate section of this manual.
58-0867-01.book Page 88 Thursday, February 13, 2003 1:18 PM