Filter
Top Products
23
Using the Stylistic LT P-600
Removing and Installing the Battery Pack 1
The battery pack can be removed from the pen tablet and swapped with a charged battery pack. The
battery pack can then be charged in an external charger if one is available. To remove the battery
pack from the pen tablet:
1. Choose one of the following:
• If a charged battery pack is available, you can suspend system operation. A built-in “bridge”
battery will maintain the system in Suspend-to-RAM mode for about 5 minutes while the
battery pack is removed; this allows time for replacement with a charged battery pack.
• If a charged battery pack is not available, save your work and close all running programs,
then shut down the system or Save-to-Disk.
• Plug in an external AC/DC power source.
2. Slide the spring-loaded battery release switch in the direction indicated in Figure 2-2.
3. While holding the switch, slide the battery pack away from the top of the system, as indicated in
Figure 2-2.
If you are using an external battery charger, refer to the instructions provided with the battery
charger.
To install the battery pack:
Orient the battery so the grooves on the sides of the battery align with the slides inside of the battery
tray. Slide the battery pack into the tray and press it firmly into the tray until it is seated. When it is
properly seated, the battery release switch will automatically latch the battery pack into place.
Once the battery pack is installed, you can resume system operation or start your system and use the
system normally.
Figure 2-2 Removing the Battery Pack
Battery
Battery
Pack
Release
Switch
58_0536_00.book Page 23 Wednesday, August 22, 2001 9:07 AM