Filter
Top Products
33
Troubleshooting
Troubleshooting Your Stylistic LT P-600
Solutions to some common problems are described in the following sections. If you are experiencing
a problem with your Stylistic LT P-600 pen tablet that you cannot solve by taking the actions
described, contact your local help desk or your reseller for further assistance.
System Will Not Resume Operation 1
If the system will not resume operation after system operation has been suspended, check the
following possible causes:
• The battery pack may either be defective, or discharged to the critically low level. When the
battery pack reaches the critically low level, the system is forced into Suspend-to-RAM mode to
avoid a total system power failure. To correct this problem, either connect an external power
supply (such as the AC adapter), or install a charged battery pack in the pen tablet.
• The system may be at the critical thermal limit. To avoid damage to heat-sensitive components,
the system enters Suspend-to-RAM mode when it gets too hot. System operation cannot be
resumed until the pen tablet cools off to a tolerable temperature. Move the pen tablet to a cooler
location.
Display Screen Is Blank or Difficult to Read 1
If the display screen on your Stylistic LT P-600 pen tablet appears blank or is unreadable, confirm
that the system is running (the Power icon is displayed continuously on the Status display), and
check the following:
• The system brightness may be set too low, causing the screen to appear too dark. Use the
brightness hotpad to adjust the screen brightness.
• An external monitor may be selected. Tap on the Display Select hotpad to determine whether the
pen tablet display screen is selected.
• The video timeout may have expired. Tap on the display screen to reactivate the display. Note that
this is a normal, power-saving feature.
Cursor Is Not Tracking Pen 1
If the cursor on the screen appears to be misaligned with the pen or is not accurately tracking the
pen, calibrate the pen. See “Calibrating the Pen” in Chapter 2 for details.
Infrared Data Transfer Is Not Working 1
If you are experiencing problems transferring data over the system’s infrared interface, note the
following:
• Can the IrDA port on the pen tablet “see” the IrDA port on the other device? A direct line-of-
sight path must exist between the IrDA port on the pen tablet and the IrDA port on the other
device.
58_0536_00.book Page 33 Wednesday, August 22, 2001 9:07 AM