Fujitsu M3097G+ Scanner User Manual


 
6–2
Table 6.1 Check items (continued)
Problem
The lamp does
not light (ready)
while the power
indicator blinks.
The check
indicator is on.
"Please clean-
up!!" is dis-
played on the
operator panel
during the read
operation.
"Please clean
Pick-roller" is
displayed on the
operator panel
during the read
operation in the
automatic
document
feeder.
Paper double
feed
Miss pick
Paper jam
Possible cause
The interface cables were not
connected correctly.
The terminator was not
connected.
The carrier fixing bracket
was not removed.
——————————
The mirror is dirty.
The pick roller is dirty.
The unallowable document
was read in the automatic
document feeder.
(See Section 4.3.)
Pad is dirty.
Pick rollers are dirty.
Some foreign particles are in
ADF
Response
Connect the interface cables correctly.
Connect the terminator.
Remove the carrier fixing bracket as
explained in Section 3.2, “Removing the
Carrier Fixing Bracket.”
Turn the power off then on again. If the
check indicator turns on again, contact the
sales person in charge or a Fujitsu service
representative.
Clean the mirror as explained in Sec-
tion 5.3.4.
When the power is turned off, the mes-
sage is cleared.
Even if the message is displayed, the read
operation can be continued. Clean the
pick roller after the read operation.
(See Section 5.3.2.)
If a document not meeting the scanner
specifications is read in the automatic
document feeder, the document is not fed
smoothly and an error message may be
displayed.
Read the document in the flat bed station.
Clean the Pad. (See Section 5.3.2)
Clean the Pick rollers. (See Section 5.3.2)
Clean the ADF (See Section 5.3.2) or
remove any foreign particles.