Filter
Top Products
3-1
CHAPTER
3
Installing the Server
This chapter describes how to install the server. It contains the following sections:
■ Section 3.1, “Checking Components” on page 3-1
■ Section 3.2, “Connecting Input Power Cords” on page 3-2
■ Section 3.3, “Connecting the Administration Console” on page 3-5
■ Section 3.4, “Powering On the Server” on page 3-10
■ Section 3.5, “Connecting Additional Peripheral Devices” on page 3-15
Note – Do not install any additional PCI cards or peripherals until the server has
been installed and booted successfully.
Caution – When raising the unit, do not grab the handles on the front. The handles
on the front are only to be used for pushing in or pulling out the unit in the rack.
They are not designed to bear the weight of the unit.
Caution – Extend only one server out of the equipment rack at a time to prevent
unbalancing the rack. The stabilizer (if applicable) must be deployed whenever a
server is extended out of the rack.
3.1 Checking Components
This section explains how to check server components.
1. Check the components against the packing list that came with the server.