Filter
Top Products
25-20 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
a. Execute the addfru(8) command and select "CMU/IOU" from the maintenance
menu.
b. Based on Section 6.2, “Active Replacement and Hot Replacement” on page 6-5,
perform the add-on operation according to the instructions displayed in the
maintenance menu.
Caution – To the add-on component, do not fail to execute the diagnostic test which is
provided in the maintenance menu of the addfru(8) command.
14. Confirm that the mounted component has been recognized by the server, and the
error indicator asterisk (*) is not displayed.
15. Use the showlogs error -v command and the showstatus(8) command, to
confirm that no errors occurred.
If you found any errors on the hardware, contact a certified service engineer.
16. Change the mode switch setting on the operator panel from Service to Locked, to put
it back.
17. Configure the following settings for the add-on CMU.
■ XSB settings
■ LSB settings
■ Addition of XSB to the domain
For each setting, see the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User’s Guide, which has the chapter describing "Setting Up XSCF."
18. When upgrading the CPU module (CPUM) at the same time, set up and confirm the
CPU operational mode of the domain.
For details, see the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User’s Guide. In the document, see the chapter of "Setting Up XSCF."
19. Power on the target domain.
20. Confirm that the target domain has been properly started.
XSCF> addfru
XSCF> showhardconf -M
XSCF> showlogs error -v
XSCF> showstatus
XSCF> poweron -d domain_id
XSCF> showlogs power