Filter
Top Products
Parameter Data Format
The HDD does not support this bit. It always reports "0" in response to the
LOG SENSE command (see Section 4.1.15). The LOG SELECT command
will be accepted when this bit value is "1." However, the HDD will save the
target with a specific algorithm, ignoring the value specified in the command.
e. ETC (Enable Threshold Comparison)
The HDD does not support this bit. It always reports "0" to the LOG SENSE
command (see Section 4.1.15). The HDD will accept this command when
this bit is "1." However, the HDD will not compare the log parameter with
the threshold, ignoring the value specified in the command.
f. TMC (Threshold Met Criteria)
This field is invalid because the "ETC" bit is "0." The LOG SELEVT
command (see Section 4.1.15) will be accepted when the value of this field is
not "00b." However, the HDD will ignore the value specified in the
command. Note that "0" will be posted for the LOG SENSE command.
g. LBIN
This bit is only valid when the "LP" bit is "1." When the "LP" bit is "1" and
this bit is "0," the list parameter is represented by ASCII codes. When the
LP" bit is "1" and this bit is "1," the list parameter is represented by binary
codes.
h. LP (List Parameter)
"1": The parameter is a data counter.
"0": The parameter is a list parameter.
If this bit is specified by the LOG SELECT command, the HDD ignores the
specified value and its operation is not affected.
328 C141-C013