Filter
Top Products
C156-E142-02EN vii
Task Alert message Page
Installation
Device Damage
Be sure to turn on the power supply before inserting your cartridge
for the first time. It releases the device from transport protection
and enables you to insert the cartridge.
The device may be damaged if you insert the cartridge without
releasing the protection. From the next time, you don’t need to
turn on the power supply beforehand.
Before moving the drive, remove the optical disk cartridge. If the
drive is moved with the optical disk cartridge loaded in it, the head
may move back and forth in the drive to damage the head or disk
and reading the data may fail.
3-18
1) Make sure that the system power is off.
2) Do not connect or disconnect any cable when the power is on.
Device Damage
Before demounting the optical disk drive, turn off the system power.
Do not remove screws securing the cables and drive when the
power is on.
3-20
3-22
Cleaning cartridge Device Damage
Be sure to use the dedicated head cleaner described above.
Damage for disk medium
Use the cleaning solution and cleaning cloth specified in Table 5.2.
If other than the specified items is used, disk media surface may be
damaged.
Damage for date medium
Do not use this cleaning kit for the floppy disk or the optical disk
cartridge used for other optical disk drive.
Damage for disk medium
Clean the cartridge at clean place. Put a disposable groves at
cleaning so that the fingerprint does not put on the disk media
(recommendation).
Damage for disk medium
At setting the cartridge to the setting case, do not apply the heavy
shock and push hardly.
Eye inflammation
In case of contact with eyes, immediately flush eyes with water.
5-6
5-10
5-11
5-12
Maintenance and Repair Data loss
In case of regular repair, the optical disk cartridge should not be
attached except where the cartridge causes the error. And before
having the drive repaired, save the data in the cartridge. Fujitsu is
not responsible for data last during maintenance or repair.
6-3