Filter
Top Products
Important Alert Items
vi C156-E228-02EN
Task Alert message Page
Before moving the drive, remove the optical disk cartridge. If the drive is
moved with the optical disk cartridge loaded in it, the head may move
back and forth in the drive to damage the head or disk and reading the
data may fail
4-2
1) The user must not change the settings of terminals not described in
this section. The terminals must remain as set when shipped.
2) Do not change terminal settings when the power is on.
3) To strap setting terminals, use the jumper shipped with the drive.
4-5
1) Make sure that the system power is off.
2) Do not connect or disconnect any cable when the power is on.
4-13
1) Be careful of the insertion directions of SCSI connectors. For a
system in which the terminating resistor power is supplied via the
SCSI cable, connecting connectors in the wrong direction may cause
the following:
The overcurrent protection fuse of the terminating resistor power
supply (SCSI device) may blow when power is turned on.
The cable may burn if overcurrent protection is not provided.
2) Be careful of cable connector positions when connecting more than
one SCSI device. The SCSI device having the terminating resistor
must be connected to the end of the cable.
3) The cables must be kept away from the rotating part of the spindle
motor.
4-14
Installation
Before demounting the optical disk drive, turn off the system power. Do
not remove screws securing the cables and drive when the power is on.
4-17
Device Damage: Be sure to use the dedicated head cleaner shown
above.
5-6
Disk damage: To clean a disk, use the cleaning solution and cleaning
cloth specified in Table 5.2.
5-10
Disk damage: Do not use this cleaning kit on a floppy disk or an
optical disk cartridge to be used on other optical disk drives.
5-11
Disk damage: Clean a cartridge in a dust-free environment.
Fujitsu recommends wearing disposable gloves during cleaning so that
no fingerprints are left on a disk.
5-11
Disk damage: Do not press hard or apply excessive shock to an optical
disk cartridge case while setting it in the setting case.
5-12
Cleaning cartridge
Eye inflammation: If the cleaning solution gets into your eyes,
immediately wash the solution away with water.
5-13
Maintenance and Repair
Data loss: For a repair request, you normally do not need to include
any optical disk cartridge with an optical disk drive. However, you do
need to include a cartridge if errors keep occurring with a specific
cartridge. In such a case, be sure to save data stored in the cartridge
before sending it in. Fujitsu shall bear no responsibility for any data lost
during service or repair.
6-3