Fujitsu Mobile Color Scanner Scanner User Manual


 
43
Error message
Because the scanner was stopped, scan opera-
tion was aborted.
You cannot select Automatic in Direction if
Halftone is selected in Image Type. Select
Manual in Direction, or select a setting other
than Halftone in Image Type.
Image data was missed.
The USB scanner device cannot be found.
Character images could not be stitched. Do you
want to scan them again?
Photograph images could not be stitched. Do you
want to scan them again?
Photograph image stitching stopped because its
preprocessing could not be performed success-
fully.
Explanation and action to be taken
This message is displayed when at least 2
minutes have elapsed after start of
scanning. Scan an original within 1 minute
at a time.
Uncheck Auto for Direction or set an item
other than Halftone Image Type, then make
the setting again.
Image data transfer could not catch up with
the scanning speed of this scanner
because the system processing speed was
low, and image data dropouts occurred.
Terminate running software programs to
improve system performance or slowly
move the scanner for scanning.
Check whether the scanner is connected
properly. Check whether the scanner is
properly selected for the application.
Check whether the scanning direction and
speed are proper. Refer to Scanning a
Large Original.
Check whether the scanning direction and
speed are proper. Refer to Scanning a
Large Original.
Memory may be insufficient. Terminate
other applications. (Recommendation: Have
available at least 128 MB of extended
memory). Alternatively, the scanned image
is too short. Scan at least 30 mm of an
image.
05_Scanner (34-49) 8/15/01, 8:40 AM43