Fujitsu Mobile Color Scanner Scanner User Manual


 
vii
Handling Precautions
This scanner is precision electronic equipment. Follow the precautions below when handing
the scanner.
Do not put any object on the scanner.
Otherwise, the scanner could be scratched or could fail.
Do not insert any foreign objects into the scanner.
Do not spray a liquid such as water or disassemble the scanner and insert any foreign
objects into the scanner.
Do not use the scanner under any abnormal condition.
If you become aware of any abnormalities such as smoke coming from the scanner, or
unusual smells or sounds, immediately turn off the power to the computer and disconnect
the scanner from the computer. Then, contact the store where you purchased the scanner
or Fujitsu service representative in charge of Fujitsu products.
Put the scanner in the carrying case supplied with it when carrying or storing the scanner.
If a failure occurs
If you become aware of a failure, immediately turn off the power to the computer,
disconnect the scanner from the computer, and contact the store where you purchased
the scanner or Fujitsu service representative in charge of Fujitsu products.
Do not disassemble or repair the scanner.
Do not install the scanner in a location exposed to direct sunlight for long periods of
time or locations subject to abrupt temperature changes, such as in locations near an
air conditioner.
Install the scanner in an environment where the temperature and humidity are
respectively within the following ranges:
Temperature: Operating: 5 to 35°C Not operating: 0 to 50°C
Humidity: Operating: 20 to 80% RH Not operating: 10 to 80% RH
(no condensation allowed)
Do not use the scanner in a location exposed to dust, corrosive gas, or sea breezes.
Do not use the scanner near any source of strong magnetic fields such as a TV set or
speaker as well as a magnet. A source of strong magnetic fields may cause a failure or
malfunction of the scanner and may also cause interference to radio or television
reception.
Connect the scanner to a USB hub with an internal power supply (hub to which power
is supplied from the power cable or AC adapter) and use up to two-stage serial
connection when required.
01_Scanner (Intro) 8/15/01, 8:34 AM7