Filter
Top Products
TX120 Operating Manual 49
Starting up and operation Switching the server on and off
5.3 Switching the server on and off
V CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section “Flickering
stripes on monitor screen” on page 57).
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 5 in figure 9 on page 44) lights orange.
– Starting up for the first time:
Ê Press the On/Off button (item 11 in figure 9 on page 44).
The power-on indicator lights up green (item 5 in figure 9 on page 44).
Ê Insert ServerStart disc 1 in the CD/DVD drive.
Ê Follow the on-screen instructions (see also section “Configuring onboard
SAS controller” on page 51 or section “Configuration without Server-
Start” on page 52).
– System already installed:
Ê Press the On/Off button (item 11 in figure 9 on page 44).
The power-on indicator lights up green (item 5 in figure 9 on page 44).
The server is switched on, performs a system test and boots the
operating system.