Filter
Top Products
ScanSnap S300M Getting Started 18
2.2 Connecting the ScanSnap
When the installation of the above programs is complete, connect the ScanSnap to your
computer.
■ Connecting the cable
Connect the ScanSnap to a power supply in either of two ways below:
After connecting to a power source with the cable above, connect to your computer
with a USB cable.
ATTENTION
Install ScanSnap Manager, and then restart your computer, before
connecting the ScanSnap to your computer.
Power source Use the following cable: See:
Power outlet
(When always operating
the ScanSnap at the same
regular place where it can
be fed power from a power
outlet)
"When
connecting with
the Power
cable:" (page 19)
Computer
(When using the
ScanSnap at a place
where it reaches no power
outlet, or when carrying the
ScanSnap together with
your laptop computer
around and operating at a
place where no power
outlet is available)
"When
connecting with
the USB bus
power cable:"
(page 20)
CAUTION
Use only the AC cable and AC adapter (power cable) below:
Otherwise, a failure may be caused.
• Manufacturer: LEI
• Model No.: NU13-1072166-I3
Power cable
The Power
cable is a
combination of
the AC adapter
and AC cable.
USB bus power
cable