Filter
Top Products
14 Installation
The following explains the names and functions of the components at the front of the XG700.
• Power LED (Green) Lights when the XG700 is receiving power.
• Alarm LED (Orange) Lights when there is a problem with the XG700.
• Status LED (Green) Lights when the XG700 is in an operable state.
• Serial Port Used when performing maintenance or adjusting the settings
(Console connection).
• Mng-LAN Used when performing maintenance or adjusting the settings
(LAN connection).
- Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
- Mng - LAN Link LED (Green) Lights when the link is established.
• Ports 1-12 Xenpak modules which connect to the IEEE802.3 ak compliant
10 Gigabit network served by the XG700.
• Link/Act LEDs (Green) Displays the condition of respective port.
Each LED lights when a link is established on its port.
The link is established about fifteen seconds after the received
signal is detected.
• Dump Switch Used to collect maintenance information.
1-2 XG700 Components
This section explains the names and functions of the various XG700 components, including the
various indicator LEDs.
XG700 front
Mng-LAN
Mng-LAN Speed LED
Mng-LAN Link LED
Link/Act LED
Alarm LED
(Alarm)
Power LED
(Power)
Serial Port
Status LED
(Status)
Port 5
Port 1
Port 2
Port 3
Port 4
Port 6
Port 7
Port 8
Port 9
Port 10
Port 11
Port 12
1 2 3 4 5 6 7 8 9 10 11 12
Console
RS-232
Power
Alarm
Status
Mng-LAN
Link/Act LED
Link/Act LED
Link/Act LED
Link/Act LED
Dump
Dump Switch
(Dump)