Filter
Top Products
32 Troubleshooting
[Symptom] The power switch is turned on, but the XG700 does not power up.
[Cause] Possible causes:
1 Loose cable, or
2 Hardware failure
[Action]
1 Check that all cables are connected properly, then (if the XG700 still doesn't turn on)
or
2 Contact the vendor's service department.
[Symptom] The XG700 has not started within a few minutes of the power switch being turned on.
The Status LED keeps blinking.
[Cause] Probable hardware failure.
[Action] Contact the vendor's service department.
[Symptom] The XG700 has not started within a few minutes of the power switch being turned on.
The Alarm LED (Orange) lights.
[Cause] Probable hardware failure.
[Action] Contact the vendor's service department.
3-1 Start-up Problems
The following errors may occurs when the XG700 is started up.
If the cause of the error cannot be resolved, contact the vendor's service department.
The following explains some general errors that can occur. Check if any of these match your prob-
lem.
The XG700 does not turn on
Status LED blinks, but the XG700 does not start up
Alarm LED lights, but the XG700 does not start up