Filter
Top Products
- 21 -
４．３ Terminal board
Use terminal board on the rear panel of
the main unit for the connection between
BK, external receiver or decoder. Insert a
connection wire in a terminal in the following ways.
Note: Use connection wire with single core 0.4~1.0mmØ or standard twist
core 0.3mm
2
~0.7mm
2
.
４．３．１ Connection of BK
Connect BK referring to attached “Layout diagram” in the APPENDIX.
BK voltage is 12 ～ 24 VDC, no polarity.
BK cable is not included in the standard supply scope.
４．３．２ Connection with external receiver
Connect with external receiver referring to article 2.5 “Operation with external
receiver” (page 17).
Insert a connection wire to a hole
while pressing the push knob
Push knob
Wire hole
Connection
wire
Press a push knob by
a screwdriver
Terminal board
Peel off vinyl sheath
of the wire about 10mm