Filter
Top Products
10
3.2.2 Receiving and automatic data rate switching
A call arrives at the data rate set on a subscriber’s equipment, and the setting of DIP
Switch SW3 determines if the call will be received or not when the data rate is different
from that set on the IB-681.
etatS3WSskrameR
citamotuaoN:FFO
gnihctiwsetaratad
tahtmorftnereffidsietaratadstinehwdetpeccatonllacDSH
.186-BIehtnotes
lanimretDSHehtotkcolcorhcnysehtnehwgnittessihtesU
.etaratadhctamotdegnahcebyllacitamotuatonnac
atadcitamotuA:NO
gnihctiwsetar
ehtfi,elpmaxeroF.etaratadfosseldragerdetpeccallacDSH
sillaceht,K65sietars'llacadnaK46ottessihctiwsetaR
DSHehtotlangiskcolcorhcnysehT.K65tadettimsnart
.K65otdegnahcyllacitamotuaoslasilanimret
:etoN ezinorhcnysyllacitamotuaotderiuqersilanimretDSHehT
.langiskcolcdeiravot
3.3 V.25bis Command, Indication
For automatic calling, the HSD terminal directs the HSD modem with commands. Addi-
tionally the HSD modem directs the HSD terminal with indications. These commands and
indications are as below.
Commands
dnammoCemaNnoitpircseD
xxNRC
⋅⋅
xrebmuNtseuqeRllaCllacatimsnarT
CIDllaCgnimocnIelbasiD.ylpercitamotuastneverP
CICllaCgnimocnItcennoC.ylpercitamotuaswollA
Consecutive commands cannot be accepted. Commands use IA5 characters. Upper case
or lower case may be input, but case cannot be mixed.
Indications
noitacidnIemaNnoitpircseD
CNIllaCgnimocnI.devirrasahllaC
VNIdilavnI.lanimretmorfdnammocnirorrE
LAVdilaV.lanimretmorfdnammoctpeccA
xxIFCdeliaFllaCNRCotesnopserni)nosaerdna("ylperdeliafllaC"
Indications are done with IA5 characters, in upper case only.