Gateway 8300 Network Card User Manual


 
8 Gateway ALR 8300 User’s Guide
Basic features
Intel Pentium
®
II Xeon
processor (speed depends on the model)
SMP design supporting up to two processor modules
Intel MP Specification V1.1 and 1.4 compliant
32-bit PCI and 16-bit ISA bus master
64-bit processor and memory data path
Extended PCI-to-PCI bridge support
64-MB error checking and correcting (ECC) memory, expandable
to 2-GB using ECC PC100-compliant 100MHz 72-bit SDRAM
DIMMs
Integrated 2-MB DRAM PCI Graphics (Cirrus Logic GD54M30)
Seven expansion slots: five PCI, one shared PCI/RAIDport, and
one shared PCI/ISA
Integrated PCI Ultra2 SCSI (Adaptec 7890) with two 68-pin
connectors, dual-channel ultra-DMA PCI IDE interface, and
diskette controller supporting 1.44 MB and 2.88 MB formats.
RAIDport III ready: the shared PCI/RAIDport slot supports the
addition of a RAIDport card to provide RAID capability.
Low voltage differential (LVD) support for SCSI devices. LVD
SCSI allows faster disk access and greater data integrity
Power supply unit that supports dual 400 W redundant power
supply modules with hot swap capability. The system ships with a
single module. If you install the optional second module, the power
supply supports load sharing and N+1 fault tolerance.
Phoenix upgradable Flash BIOS, Year 2000 Ready
The system is equipped with InforManager
(IFM), a special
feature consisting of both hardware and software designed to
monitor and report the operating status of the system and its
devices: processors, power supplies, RAM, ambient temperatures,
voltages, and fan operation. For further information about the
InforManager
, refer to the InforManager
User’s Guide.
4080TL.book Page 8 Tuesday, December 22, 1998 2:50 PM