Filter
Top Products
27
www.gateway.com
Adding or replacing memory modules
4 If you are removing a module, gently press outward on the clip at each end of the
memory module until the module tilts upward.
5 Pull the memory module out of the slot.
6 Hold the new or replacement module at a 30-degree angle and press it into the empty
memory slot. This module is keyed so it can only be inserted in one direction. If the
module does not fit, make sure that the notch in the module lines up with the tab
in the memory bay.
7 Gently push the module down until it clicks in place.
8 Replace the memory bay cover and tighten the cover screws.
Important Use only memory modules designed for the Gateway M275.