Filter
Top Products
NETCOMM GATEWAY™ SERIES – NB304N – ADSL2+ Wireless N300 Modem Router
22
NetComm NB304N – ADSL2+ Wireless N300 Modem
YML304X
www.netcomm.com.au
In the case of a PPPoE connection, the following options are available:
PARAMETER
DEFINITION
PPP Username and Password
The username and password required to access the service
PPPoE Service Name
A name to identify the configured service
Authentication Method
Select the authentication method in use on the service
MTU
Set the Maximum Transmit Unit (MTU) size for the connection
Enable NAT
Select to enable or disable Network Address Translation (NAT) for this connection
Enable Fullcone NAT
Select to enable Fullcone NAT on the connection.
Dial on Demand
Select to enable dial on demand mode. Enter the idle time to wait before disconnecting the service.
PPP IP Extension
Select to enable PPP IP Extension on the connection
Static IPv4 Address
Enter a static IP Address to utilise with the connection
Enable IPv6
Select to enable IPv6 support for the connection. This enables the NB304N to Request Prefix Delegation and
request an IPv6 Address.
Enable IGMP Multicast Proxy
Enable IGMP Proxy mode on the connection. This is commonly used for IPTV.
Enable MLD Multicast Proxy
Enable MLD Proxy mode. This is the IPv6 equivalent of IGMP proxy mode.
Click Next once the connection configuration details have been entered.
(a)
Select the Default Gateway Interface to use for the connection and click Next
(b)
Select the DNS Server Interface to use for the connection and click Next
(c)
Review the configured functions of the connection and click Save/Apply to save the new WAN Service
connection.