Filter
Top Products
Falcon 36 Operation Manual Maintenance and Troubleshooting
GBC Pro-Tech 1997 October 4-7
/XEULFDWLRQ
Tools required:
•
1
/
8
" hex wrench
•
High temperature grease or lithium grease
•
Grease gun
To lubricate the laminator:
WARNING
Do not lubricate the laminator when it is hot.
You can be burned.
WARNING
Unplug the laminator and make sure it won't
be plugged back in while you are performing
this procedure. You could be severely
shocked, electrocuted, or get your fingers
caught in the drive mechanisms.
1.
Remove the drive and control side cabinet
covers using the
1
/
8
" hex wrench by removing
the six screws holding each cover in place.
2.
Using the grease gun, lubricate each grease
fitting (shown in Figure 4-7) with one squirt of
high temperature grease.
©1994 HCS, Inc. 800-748-0241 Reorder No. 1012-PT
Moving parts can
crush and cut.
Do not operate with
door open.
WARNING
ACHTUNG
MISE EN GARDE
Grease
Fittings
Figure 4-7:
Grease Fittings
3.
Lubricate the chain using a soft cloth and
automotive oil.
4.
Replace the cabinet covers and reconnect power
to the laminator.
&RQWDFWLQJ7HFKQLFDO6XSSRUW
For machine parts and technical service:
North America
: 1-800-790-7787.
Europe
: +44 (0) 1844 202 440
or fax: +44 (0) 1844 202 441.
Please provide serial number when calling for
service.
For film and application questions:
North America
: 1-800-236-8843.
Europe
: +44 (0) 1844 202 440
or fax: +44 (0) 1844 202 441.