Filter
Top Products
Maintenance and Troubleshooting
F-36 PRO Laminator Operation Manual
4-2
© GBC Pro-Tech 1999 January
Figure 4-1: Adjusting the Thermocouple
Once installed, the critical point of the thermocouple
MUST make direct contact with the roll as shown in
Figure 4-2.
Figure 4-2: Correct Thermocouple Contact
CAUTION
5. Replace the thermocouple and tighten the screws.
6. Repeat the procedure for the other thermocouple.
Firmly hold the thermocouple where the “guitar
pick” sensor is riveted to the aluminum base
while bending. You can break the sensor off the
base if you do not provide this added support.
Provide
Support
At Rivets
Use Your
Other Hand to
Gently Bend
Roll
Thermal
Junction
Rivets
Bend